5 QUICK STEPS TO PERFECT BINDING
CLAMP * MILL * GLUE * COVER * DELIVER

1. CLAMP

Built of extra-strong cast aluminum, this machine is easy to regulate. Perfect parallel regulation by means of simultaneous movements of both sides of the drawer.

Positioning system; mechanical stop in 150mm long rail, allows a perfect stop for the clamp to receive the cover without any variation between the cover and inside section. This has the added benefit of increasing the life span of the engine because it only has to stop once in each cycle.

2. NEW MILLING SET

This milling was especially designed to offer a more perfect cut and greater durability to the hard material disc. It is powered by a 3HP engine. This set has two blades that cut deep channels on the spine of the book, which allows a better penetration and adherence of the glue.

The milling set with more teeth reduces the excess of chips and increases cutting durability. The blades are made of extra strong steel, which permits various types of sharpening and practical fine adjustment.

3. GLUING SET-HOTMELT

It’s an independent starter. The heating system with more homogenous distribution and a precision electronic thermostat promotes a longer life span of resistance. It has two rotating cylinders with independent regulations and two regulating applicators to apply glue on the side of the spine.

The Baby-Binder may be supplied with the option of a mechanism for applying cold glue (without the resistance or temperature regulator). A gluing set with more electrical resistance and operating with fewer watts distributes the heat better and increases its life span.

4. PNEUMATIC COVER PRESS

This exclusive system with pneumatic pressure was developed combining a synchronized mechanical-pneumatic system. This Exclusive System allows the spine of the book to become Perfectly Square. It is a cover positioning system and does not require fine adjustment. This is a world exclusive system. It allows the operator, with a simple touch of a regulator, to make a perfect spine for a magazine between 3mm and 50mm, using covers of various weights, with or without
a groove.

The pneumatic pressure stands out by its rapid and very efficient response to a change in shape or thickness of the spine. As noted, mechanical pressure leaves much to be desired. In the case of thin spines, the system of springs exerts excessive pressure causing constant creases and making the operator's job difficult. In the case of thick spines (over 25mm) the problem is the opposite: there is not enough pressure and the spine ends up rounded.

5. DELIVERY
“Toboggan” type delivery output.