KTA100/1(01) model is a dry running rotary vane
pump with a vacuum and pressure port.
All vacuum air is filtered by a built in micro-fine
filter. The carbon dust which is the result of
the carbon blades wearing is also separated by
built-in filters. A high efficiency cooling fan
is located between the pump housing and the motor.
The pumping unit is encased in a rugged black
sound enclosure. The compressed air is cooled
by an after cooler. The pressure/vacuum pump
is driven by a direct flanged three phase, standard
TEFV motor via a pin and bush coupling. Pressure
and vacuum can be adjusted to the required levels,
however, they are limited to a maximum point.
/1 is for standard vacuum and pressure capacity
ratio; model /2 is for maximum compressed air
model /3 is for maximum vacuum capacity ratio
and model /5 is for increased pressure. Versions
(01) to (30) are with
cooling exits from two sides whilst
versions (31) to (60) are with a cooling exit
on one side only.
All models have nominal capacities of 40, 50,
80, 100 and 140 m3/hr operating at 50 cycles.
The pressure and vacuum limits (bar) are indicated
on the data plate. The tables showing capacity
and vacuum can be seen
in the specifications section below