Bench Top 220 mm Plate Punch
NELA Bench Top 220 mm Offset Plate Punch is
used for punching register holes into the leading
edge of printing
plates. It can be used with a printing press
which uses a register pin spacing of 220mm such as: Heidelberg
QM-46, GTO-46, GTO-52; Adast Ramayor, Dominant 506, 705,
706, 806; Ryobi 3000, 3200, 3302, 3304; Hamada 52, SA-651,
SA-666. Not all of the presses have been verified by the
seller to work with this plate punch. It is the buyers
responsibility to review the punch pattern photo
below to be certain this
punch will work with their press before purchasing it.
us with any questions you may have.